Fired up new engine.

Discussion in 'Drag Racing' started by ray-g151, May 7, 2016.

Page 2 of 2
  1. Mavric65

    Mavric65 Member

    Joined:
    Feb 1, 2016
    Messages:
    13
    Likes Received:
    4
    Trophy Points:
    11
    Location:
    Sacramento California
    Vehicle:
    1973 Maverick
    What headers do you have on there and what size are the primaries 1 5/8 or 1 3/4 and are your towers notched for that 351 based motor
     
    Mavric65, May 10, 2016
    #16
  2. ray-g151

    ray-g151 Member

    Joined:
    Feb 15, 2005
    Messages:
    137
    Likes Received:
    16
    Trophy Points:
    61
    Location:
    Hatboro, PA
    Vehicle:
    1971 Maverick 412w , 1969 Cougar 427w, 1973 Maverick 306w
    I installed the AJE front end and the shock towers are cut out. The headers started as Hookers for a 351 in a fox. I had to move a couple tubes on the drivers side. They have a 2" primary with a 3.5" collector.
     
    ray-g151, May 11, 2016
    #17
  3. dan gregory

    dan gregory Member

    Joined:
    Mar 3, 2013
    Messages:
    835
    Likes Received:
    49
    Trophy Points:
    71
    Location:
    chesapeake va
    Vehicle:
    1970 maverick
    With that set up & at least a 28in tire,if you are going to spin that eng. near 8000rpm,LOW 9s should be no problem.GOOD LUCK
     
    dan gregory, May 11, 2016
    #18
Page 2 of 2

Share This Page