Firewall and wiper stuff needed

Hey gang. Im looking for some parts to put together my firewall and dash. I need to know where to get the following:

-plastic/rubber sleeves that mount over the windshield wiper shafts
-wiper arm to cowl seal/gasket
-gasket/seal for the steering column plate on the firewall

Anyone have ideas? Will I be making this stuff myself? If so, what kind of material will I need?

Thanks

 

1. don't know what part you mean...
2. got mine from mustangsunlimited, autokrafters will have them, too
3. autokrafters sells this seal

 

know onw makes covers for the wiperarm shafts...and autokrafters for the rest as stated above

 

are they needed?

 

No one makes them.Have to get them from someone or a parts car.And no,not needed.If i remember right only the driver side had it,(from the factory)and the passanger side was empty.

 

What does ONW stands for?

 

Look at the quote two posts before your, in there it says "know one". The post was either edited after it was quoted or corrected by GrabberGT. Either way, I think he was saying "no one".

 

Right on, thanks.

 

I bought a kit of various size rubber grommets from Harbor Freight. There were some that fit snug over the outer wiper shaft and fit the hole in the cowl. What I did have to do was freeze the grommets to make them hard and then sand down the top side so that the wiper arms would not drag on them. I put them on both driver and passenger side. For the underside cowl gaskets I used reproduction early Mustang leather ones. The foam steering column to firewall gasket is available, it may be a Dennis Carpenter piece, I cannot remember.

 

Thank you Jason, your knowledge is greatly appreciated.