floor pan reso

torque box is welded in and paint and i got part of of the floor pans tacked in

 

i didnt get to work on it this weekend because my car is at school but today i finally got the passager side in it 90% welded in i guess ill start on the drive side tomorrow

 

It usually is, once you get in there and start stripping it down..... Looks like your going to get it repaired properly.....

 

yea the drivers side dont look as bad as the passeger side but i dont know yet intell i tear into it...and yea its getting a proper repair or the best i can do and i dont plan on doing things any other way do u got any tips

 

heres the driver side befor i started cutting and after i cut it out

 

Inspiring. I love the pics on the post.

Inspiring. I love the pics on the post.

 

thanks i forgot to take any to day but i got the torque box finshed on the drives side just that much close to

 

well driver side is welded in and got the car up in the air the to weld the bottom side and i got to make seat braket

 

Looks good! You have gotten more done in two weeks then i have in 3 months!!!!

 

today makes A week and one day sence i started cutting

 

well got the floor pans done still like making a passager side seat bracet and redoing the drives side it sits to high up and about 2 inches to far back

 

I like the work you did on the driver's side floor pan - nice and tight

 

thanks

 

I just cut my floor out tody. There was a little rot but the main purpose was to remove the humps in the floor since I have mustang sliders I am installing on some Audi seats.

 

sounds good hope you dont got no problems