modmav

stripping paint

stripping paint
modmav, Oct 17, 2016
    • Metionic
      Did you use any kind of chemical stripper or just straight sanding?
    • modmav
      I used stripper and a wire wheel on an angle grinder. mine had two coats plus primer, I applied stripper let it set then scraped it off with putty knife than more stripper, then wire wheel. its messy (notice the plastic hanging) then rinsed with lacquer thinner then 80 grit DA need to use a good stripper I think mine was called Pro-strip. I used a small wire wheel and die grinder in tight spots, you need to rinse with the lacquer thinner or the sanding disk will plug up
    There are no comments to display.
  • Album:
    My 70 Mav
    Uploaded By:
    modmav
    Date:
    Oct 17, 2016
    View Count:
    1,328
    Comment Count:
    2

    EXIF Data

    File Size:
    820.2 KB
    Mime Type:
    image/jpeg
    Width:
    2048px
    Height:
    1536px
    Aperture:
    f/2.8
    Make:
    EASTMAN KODAK COMPANY
    Model:
    KODAK Z730 ZOOM DIGITAL CAMERA
    Date / Time:
    2005:01:08 19:00:35
    Exposure Time:
    1/60 sec
    ISO Speed Rating:
    ISO 140
    Focal Length:
    5.5 mm
     

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).