Separate names with a comma.
It does. I actually put a mechanical temp gauge under the hood so I could watch the temp at stops and just moving down the road. With and without...
That's what I did when I did an AOD swap into my 72 Grabber back in 2000. Before we had the great internet we do now and all the parts there is...
This is the joy of dragging one across the dirt to load it on the trailer. Have good tires if you can when you recover one. Fortunately the TQ...
My other toy, 66 Stang, 331 stroker, C-4 8" 3.55 posi.
Crites headers. Haven't run it at the strip. I know it'll smoke them up from a stop light and bark them going into 2nd. I have run it up to...
Yep sure did back in 1992 and Drag racer it and drove it for 10 years after doing it. It is actually still being raced even now by a new owner...
NASCAR mechanics studied this to find the best place for cooler air from the hood area. They found the base of the windshield is the highest...
I did that once on a 82 Zephyr I put a 460 in. Put a temp gauge under the hood with it ran under the wiper blade to hold the gauge in place. At...
How early of build is it? They started in early 69.
I see your supervisor is watching your every move. Pull the trans with it to and inspect it. Drain it first. The "creamy" stuff in the thermo...
The center thingy, AKA steering center link, is what you're rubbing on. It's not a big issue that they rub, the bigger issue is the type of rubber...
Also weld in some frame stiffeners.
Trailer ones usually are 3"+. My car trailer is a Ford Bronco bolt pattern and center hole, while my travel trailer is a Ford car with a 3" center...
I use Class C on my dual axle car trailer, 50PSI and Class D single axle, on my travel trailer 65PSI. Low air pressure will heat a tire up fast.
sounds like the wrong tires. You have to not only use tires for trailers, not car tires and ones that are rated for the load you carry. Even cars...
Well wasn't on my Comet but it was on my trailer. So those of you with car trailers (I have one of those too) or especially travel trailers, be...
If I don't sell it soon, I'll be putting headers on it along with a few other things. But I didn't want to change to a floor shifter either.
Most of the people that work there won't know an engine from a spark plug if you dropped it on their foot. Good score.
It's a C-4. I used B&M 8' cable, and shifter adapter parts from B&M, along with a Fox V-8 gas cable bracket and modified it to go over the stud on...
Got rid of the column shifter linkage and kept the column shifter without going to a floor shifter. Now I can put headers on and still have a...
