Separate names with a comma.
Cool - glad you finally got her in there. Haven't been on this forum for months and find you post. Good timing. How did the cradle install go?...
I second the bad coil. Cleaver
Just looked at your build thread...did I see an exposed spot that showed the console made from plywood or MDF covered in carpet? It looks great...
Yep...depends on what drive belt system you put on. Water pump needs to match. Fox body Mustang serpent belt systems are reverse rotation. Cleaver
I think you are on the right track.....I'll guess something in the centrifugal timing advance. The plate will not move around, but the centrifugal...
NAPA sells sealer primer in a rattle can that is real good. I have used it just like you are saying....when you are doing body work a little at a...
Lots of fun for sure. Something your boy will remember the rest of his life. Cleaver
I second that. Get the 6 pack of small cans. I have only been able to keep this stuff for a couple of weeks after it is opened. It is too...
I pulled a pan fill C4 out of a 78 LTD II at the Pull-A-Part a couple of months ago that had one of those. The car had what looked to be a fairly...
I hear the "nice Nova" comment just about every time my Mav goes out. I doen't even say anything anymore...just tip my hat and wave. Cleaver.
I like the Stealth. Real similar to the original Edelbrock RPM. Got a 351 Stealth on my Fairlane right now that I made into an Stealth Air Gap...
Hahahahaha. I have that on a board above my desk at work....only mine starts out with "We do 3 types of work around here:" One of my bosses used...
Possible thread hijack - Didn't someone have a line on stainless ones from Brazil? Did that die? Nevertheless Dave - nice score! Cleaver
You are going to have to make motor mounts anyway...so who cares if the engine sits a little higher than stock? You will just need to measure the...
Is there a big block AOD version? I thought you had to mill the bell and weld on an adapter plate to adapt to a big block? Nevertheless - it looks...
Doesn't the car have to be NEWER than 84 to qualify as a clunker? Cleaver
I have a 250 C4 with the 6 converter behind the 302 in my F100. It is a 266 cam, ported 351 headed engine that I run out hard. Always heard the...
^ | | | My apology for the thread hijack...but that avatar just cracks me up.:rl: Looks like baby Nosferatu.:rl: Cleaver
A little "good neighboring" has allowed me to get away with a lot. Generally try to think of others above myself, share my time, and lend a...
That is just an awesome story. Thanks for sharing. Lots of wisdom in that little clip. If you can see it....absorb it. Cleaver
