Separate names with a comma.
Finally got the 347 up and running in the Comet, next step is the saggy rear suspension. I am also ordering subframe connectors from chassis...
Any issues putting this piece on a 74 that has a small bumper swap? I assume I'd just have to drill a couple holes?
Thanks for the responses! Looking at that picture, it seems like somebody made a ''custom" center link bushing at some point the metal sleeve I am...
I was replacing the idler arm on my Comet yesterday and there is, what looks like a 3/4" piece of pipe, that was acting as a spacer between the...
Suspension needs work Wow that looks great! I would love to get my engine bay that clean.
Thanks Chip, it's an AZ car so I don't think that will be an issue, but I will check it out to make sure.
Hello all, I pulled the engine on my Comet last weekend and am wondering if there are any upgrades I can do while the engine is out? I am...
TKO is already in the car and has been for a few years. We did have to perform a little surgery to get it in.
That's good news I was under the impression that the 8" would be a major weak point. I am not planning on running slicks either. What is involved...
Ok thanks, I'll look in to them. Transmission is a TKO500 with less than 10,000 miles on it so it better hold up! haha
Car has disc brakes on the front already.
Hello, I am planning on swapping my 302 out for a 347 in the near future and was wondering what additional/supporting upgrades I should be...
Hello everyone, I have a 74 comet gt that I am getting rid of the big bumpers on. I mocked-up the earlier model front valance I bought over the...
