Separate names with a comma.
Mine is the SAME thing!!!! one connector has 4 wires and the other has 2 wires. I need to change my switch and I can't find out which switch to...
I hope this works being an old link.. What do you mean by slotted? Mine is doing the same, but my bolt holes don't have slots.. Can you take a...
Ronald Hopkins.... See this......
I am getting close to installing my gasket.. There is a TRACK at the bottom of the door. I have Not got ready for the gasket. But is this this...
1972 Ford Maverick Grabber 2K93F128096
Got it! Thanks!
I just got my set of bottom door gaskets from A.K. I thought there would be a 3m type of peel and stick, but there isn't... Do I need to get...
Whoops!!! Wow!!!
A while back, There was a post from someone who was rebuilding dash pads on here. Does anyone remember who that was?
I had bought some KBS floor pan and trunk sealer for my floor pans.. Since this MIGHT not be to bad, do you think that stuff might work to seal it?
It appears to be leaking around the hole where the flange might have been welded on... It SLOWLY starts to get wet like seeping though...
Not yet, I need to remove the heater box first, I am going to do that this afternoon. The leak is coming down where is side kick panel towards...
Guess I have something to work on tomorrow. The cowl has a small hole in it.. I should be able to fix that from inside when I take out the...
Is it a big job to pull the box? 1 hour? 6 hours?
I am going to try to get all the leaves out of my heater box and put a Cowl cover on the outside. How hard is it to get all the leaves out of the...
That PN# has a small pin and clip at one end and a screw at the other.. The Maverick has a screw at each end.. I guess I can drill out the hole...
I am working on a 1972 Grabber w/ a floor shifter. I am looking for this black rainbow shaped piece. I found some for the mustangs, but the...
Woo hoo!!! Thanks! :)
Yeah, I just want to keep the leaves and crap out of my vents.. Magnetic would be nice, so I can drive with it on. :)
Does anyone make a Cowl Cover for a 72 Grabber? I saw online where someone was.. But never heard back. Thanks, Chaz
