Separate names with a comma.
well boys I gotta tell ya.....I feel like a real doodad.....I've been fooling with cars for over 50 years. my no crank problem was because I had...
hummm......doesn't crank jumping the solenoid.......I'm positive the battery and starter are good and the solenoid is new....it will crank if I...
thanks
do I need 12 v from the ign. switch to the small terminal on the solenoid?.......the wire I'm using reads 5.5v and all it does is click the...
I leave the bolts to the block in with only a couple of threads until I get the thru bolts thru
NAPA.........most of the auto parts stores sell engines at good prices and are guaranteed.....ur talking about a stock 6 cyl. don't make it harder...
auto zone
bingo..........
runs then stops......sounds like crud in the gas tank .lines or filter
INSTALLED 302 ROLLER WITH AOD.....NEXT DAY MADE TRANS MOUNT...NEXT DAY DRIVE SHAFT MADE AND IN ALSO MOUNTED PAIN IN THE ASS ALT. IN BETWEEN GOT...
What shifter are aod guys using.....simpler the better...floor shift
according to Thorley tech the new shorties THY-268-1-C....fit with no problems. they were built for a 302 mav. with motor in car.........my mav...
I'm surprised that bbk or jba shorties don't fit ....anyone use 289 hi-po factory cast iron they must fit ???
do they go on before you put the engine in or after it's mounted? I see two part numbers....268-1-c and 2681-c are they the same headers? I do...
anyone know/like the best/easiest fitting shorty header for 302 in a naverick....no power steering or brakes. thanks
anyone use factory ho mustang headers or after market jba type for a 302 maverick swap? if so do you put the headers on before you install the...
got the grille....very nice...great price.....I'm impressed.
I just bought a Charlie yan grille and it's a very nice piece...well worth the money.....u couldn't build one for the price.
I ordered one yesterday....thanks for the info
