The specs on the Motorcraft FL300 says it doesn't have Relief or Anti-drainback values. The FL1A does. Is that a potnetial probelm if I use the...
Hi Everyone, I am using the Motorcraft FL1A oil filter on my 302. I saw a guy with a 302 in a '32 Ford. In order to clear the frame rail he has...
Has anyone used any of the newfangled spark plugs in place of regular plugs. I was considering the E3 or Splitfire to get better spark. Are these...
Success:yahoo: Took me 20 minutes to change out. I moved the heater controls to the right and it gave me enough room to work. Thanks for all...
Can someone tell me what size and thread the instrument cluster screws are. Mine didn' have any to compare to.
OK, how do I remove or just move the heater switch out of the way. Can it be done from the front. Or does it have to be done from the back like...
It looks like I'm going to have to take out the tray to get better access under the dash and reach the switch. Will that give me enough room to...
OK. I understand mostly how to change it out. But where is the nut you refer to that is holding the switch on. Is it on the backside of the...
Hello Everyone, My headlights have started to go off by themsleves. When I move the headlight switch dimmer they will come back on, then go off...
That makes sense.............Thanks for the info!!!:2thumbs:
How much fluid is the proper amount for a Ford 8" rear end. I have a leak and need to know how much to put back in after fixing. Thanks!!
Hello All, I'm having to shut the doors awfully hard for them to fully close. Are there any adjustments I can mke to the latches or mechanisms...
Hello Everyone, My Duraspark Ignition module went bad on me. Before I replace it I was wondering what you all thought about the reliability of...
If I was to keep this distributor, and just swap parts out, what are the steps to removing the module, stator etc......thanks!:hmmm:
Thought about the fuel filter too. I've changed it twice. Now I have a clear one on and the fuel is clean.
After I did an extensive burnout a few months ago I'm having this problem. After driving at highway speed for a couple of miles the engine kicks...
I'm trying to put in a Pertronix ignition module and I can't figure out how to remove the existing module. It appears to have a magnetic clip on...
Thanks for the info. I'm thinking about just replacing the electronics and not the whole distributor. Considering the Pertronix I or II. I...
Yes, it's still on.
I am about to install a new distributor on my 302 50H0 w/external coil, never done this before, and was wondering if anyone could detail the steps...
Separate names with a comma.
