good choke wire switch source

Discussion in 'General Maverick/Comet' started by x72COMETx, May 23, 2015.

  1. x72COMETx

    x72COMETx Member

    Joined:
    Jul 23, 2012
    Messages:
    1,069
    Likes Received:
    182
    Trophy Points:
    163
    Location:
    Vallejo CA
    Vehicle:
    1972 Mercury Comet, 1972 Mercury comet GT, 1975 mercury comet (RIP), 1974 ford maverick (RIP)
    I was wondering were would be a good place to rum my electric choke wire from, I was thinking the resistive wire that runs 6 volts?
     
    x72COMETx, May 23, 2015
    #1
  2. mavgrab302

    mavgrab302 MCCI Florida State Rep

    Joined:
    Nov 24, 2007
    Messages:
    4,475
    Likes Received:
    140
    Trophy Points:
    147
    Location:
    Ocala,Florida
    Vehicle:
    71 Maverick Grabber
    I ran a wire from the accessory stud on the fuse block out to a painless circuit boss. I in turn use that to run my choke,dizzy and fan...
     
    mavgrab302, May 23, 2015
    #2
  3. tody

    tody Member

    Joined:
    Apr 12, 2008
    Messages:
    1,835
    Likes Received:
    218
    Trophy Points:
    178
    Garage:
    1
    Location:
    cologne, germany
    Vehicle:
    72 comet gt, 67 club wagon, 65 mustang
    the STA connector on the alternator is also a good source.
     
    tody, May 23, 2015
    #3
  4. bmcdaniel

    bmcdaniel Senile Member

    Joined:
    Jul 2, 2002
    Messages:
    6,822
    Likes Received:
    681
    Trophy Points:
    318
    Location:
    York. PA
    Vehicle:
    '70 Maverick Grabber
    My car has a 3-position plug for the ignition that comes right out of the firewall, I just tapped into that. It wasn't being used anyway since I have EDIS ignition.
     
    bmcdaniel, May 25, 2015
    #4

Share This Page