Brakelines 70 Mav

Does anyone know where you can get front brakelines for a 70 Mav reasonable? Need one on each side...

Thanks!!!

 

You could bend and flare your own lines reasonably

 

http://www.getdiscbrakes.com/drop/Catalog/Maverick-Comet.pdf

Hope this helps.

 

Thanks, sent it to my guy doing the work. Hope this works. I don't know bending, I just do the body stuff

 

The rubber lines are impossible to find.

 

Are you saying that you know how to un-bend stuff instead of bending stuff?

 

This is true. It's worth the effort to go ahead and convert to 68 Mustang or later Maverick hoses. I went with Mustang hoses, they'll always be available.

 

what all is involved to do this?

 

I bought 2 used Mustang hose brackets to bolt to the frame to hold the hose (same location as a 68 Mustang). Installed Mustang hoses and wheel cylinders. The factory Maverick hard brake line was too short so I made another line to tie them together.

 

For the rubber lines I bought steel braided lines from Just Breaks off of E-bay, and for the steel lines I bought a kit from " The right stuff". I can not tell you how they fit because I am still working on the engine bay/front end, but they mocked up ok.

 

I'm not good with that stuff or mechanical. I can do body work and paint only, sanding and so on...

 

I attached 3 pics he took for me. I can show him the 68 mustang post you did. But doesn't anyone have these lines somewhere?

Banjo fitting 3/8"

Female end 7/16 by 24

Complete hose.. approx 19.5" -20 " in lenth left and right specific

Dianne

 

Those hoses are obsolete. You might check with a shop that makes hydraulic hoses to see if they can use the metal ends and create new hoses

 

David, the mechanic, is going to try the Mustang thing that was posted by predfan2001. He read the thread also. This car is a pain ahahahaha But worth it!

 

Has anyone tried what predfan2001 is talking about using the Mustang parts?