i pulled them from my 72 Mexican Maverick
he told me the clips are on the outside , then on the inside of it
He got the one behind the toploader
But the one on the rear end, is an odd one.
Can’t find the u joint
My mechanic says it’s the other type of u joint
It’s the one for the the rear axle end on the drive shaft
Got a cool induction hood for it
Looked at it a bit
It’s almost ready to have the 3pg seat brackets welded in
Waiting on a open...
I did hear that someone said 67 Mustang spring mounts might work
I’ll see if I can get some pics of the stang an upload them on this page...
So good news
Got the rear end it’s out of a 73 Grabber v8 car .
I do still have the 66 lower spring plates
They gave us the u bolts as well....
It was removed when I bought the car .
That is why I’m asking for
So I’ve got a lead on a maverick 5 lug rear
Two leads actually
Well I’m looking to install it on my girlfriends newly purchased 66 A code...
Bought new headlights ,
Digi tails Leds for the bobcat tails
And pulled the trans to prep for
Exchanging the clutch
Pulled he bobcat tails off...
[ATTACH] [ATTACH] [ATTACH]
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Little update I pulled the old tank
And filler neck....
Where would they sell the mustang rubber hose ? Any repops ?
I appreciate that post
Once I drop
It all in
All I’m gonna need is a non ca gas cap
An a different rubber seal
Well this one is the very first prototype
They want me to test fit it in the 70
Once I get it in I can report back to Acp
I also am...
Anyone have any tips on the ca emissions
For the gas tank
Should be ok to eliminate all of it
But I still want to keep the ca gas cap....
I recently got a reproduction gas tank
It’s a prototype non ca car
I had some questions
Can I install it in my ca car
Once I’m finished with my midterm
Going back to work on it , I’d say this coming fri & sat.
I’m also waiting on the seat brackets ,...
Little update got some time on the Mav today . Pulled the passenger side header
Pulled the starter
Engine won’t spin over
The pressure plate is...
Yes sir I did
I’m praying it’s just the starter
If not it will be torn apart I guess
Also the guys made me some 3 d printed door emblems
I can reach out to them if you guys are interested
Here’s a pic of my wood grain deluxe door...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Got the radiator in from engineering cooling products
The metal hoses from summit
Separate names with a comma.