According to Holley you are right to use a power valve below that of idle. Are you sure that you have only 7.5 inches of vacuum at idle? That is...
It is the charcoal cannister that absorbed the tank vapors. Without the hose to the air cleaner it is of no value.
Take Old Guy's advice. There is just not enough capacity to handle the starting current draw of the fan motor. I would make sure the...
Check page 228 of the Haynes book. You will see all 11.03". The drum brakes are 10". Check the part numbers for all the cars that use the same...
Good point! I never had a need to look at that kind of installation. If one looks at the part number specified for Mav/Comet/Granada/Monarch,...
I don't know if that is the case, about the Cobra, but as you stated it, it is possible to do that at the ECM level as long as all the dynamic...
First off 'if' the wire harness from the plug to the injectors in the engine bay are wired as batch fire, changing them at the ECM would not...
I would like to add more to this subject. The non HO motors were all speed density controlled and did not have sequencial fuel injector control...
Brakes. I don't understand why your asking about disc size. On both Mav. and Granada/Monarch and Lincoln they are all 11". Mustang II are...
In the 85-91 E/F trucks, the injectors are batch fire meaning 4 at a time. A look at a drawings shows this.
Tomm, it would cost you so much money and headache to put the $300 motor into the car that you could spend the same amount or less on a stroked...
To big and heavy for the engine size and amount of work to put it in. Often times even when someone gives you something, it's still not a bargin...
Nothing different. I think your in for a new master cylinder. Just a coincidence it happened.
This is what I do and never fails. Use a large hammer on the end if the spindle mounting point where the joint taper comes through. Hit it hard...
david, just something a little different on the subject of heads. Air flow is the thing you are after, that raises power as well as improvement...
Doug, it only supplies 5 volts to the fuel gauge circuit according to my info. If you need more info to trouble shoot the circuit, give me a hoot....
There are some things you need to know about this head project. Milling to go a full point in compression will require quite a bit to be taken...
I don't know about column shift. They don't come close to any power steering parts. I will say that the out let fit on the steering side will...
I also have the 88-400 on my Comet with floor shift automatic. I to, cleared a protrusion from the bell housing. I went a step further and...
I understand what you said, but for ignition, it's not quite like that. If all it takes is a hi voltage coil, MSD, Jacobs, Holly etc would not...
Separate names with a comma.
