you will need a disk brake proportioning valve
you need to find out if the c-4 had a 3 clutch drum(6cyl) in it if it did you need to find you a 4-5 clutch v 8 drums you will be back in it with...
if you run low at the track on type f most of the GM boys use it GM guys i race with use it helps them to keep up with the fords:D
sure looks good keep up the good work your grill looks good but if you need one i have one that you can have if you need it was in a maverick the...
its a hard job after you get the rivets out you have to get the spot weld off the pad the jont is made together i just got a new arm for 29.00...
GOOD NEWS the aerospeace has a kit for the maverick drum four hole back plate (AC-217) are the granada-maverick disk three hole back plate im...
YES for me Im down for the year truning up the heat in the old 302 should have some good numbers in the spring to post :D
excelience job john very good info i just drag race my maverick the aerospace roter hub & calipers two piston are 15 lb each side and they have...
im sure i seen a picture on here were someone had a set on a maverick im looking at the drag disk kit two piston good up to a 2400 lb car we...
im looking at a set of the aerspace components are wilwood has anyone used this kit they dont list one for the granda or maverick spindel i...
someone had a picture of a set of aerospace aluminum hub kit on their maverick i need a kit number and what spindle they have and has anyone...
i just parted out a 76 two door gave 50.00 i put it up on stands took it apart i got about 1000.00 out of it it was a v8 car the first thing i...
leave your race car at home and take a Focus it pays more money its fords super class 18 sec car the last time i went it payed 2000.00 first place...
springs came from coil springs specialties st marys ky you need to know the front end weight 785 437 2025 the falcon springs are bolt in when you...
it is a 9" mustang with a stock 31 spline ford axle 3.70 ford gear with full spool the full spool cut 25 lb out of the rear end
i take the shaft out of the trans and drive a 3/8 steel ball in the end of the outer shaft it came out of eliminating the shaft and oil leak it...
i have 1968 falcon springs they move the rear up one inch with the ssm bars and a 50/50 shocks you have to have them to make this work i have cut...
thanks this was at baytown they keep the track ready to race at all times i had a lot of fun this year at baytown we ran for points their the car...
do you have a picture of it
the SSM T bars they work good on the old maverick
Separate names with a comma.
