you will need to swap out the ball stud for a small block/I6 mustang one. this mustang stud will use a 7/16" ID X 1" OD spherical bearing. the...
I got some work done on the linkage today. [IMG]
I got my parts in today, now I have to get this done so the mav is drivable again. click on pic to see full size [IMG] [IMG] [IMG]
did you hit a pothole?
I run 100% Lucas oil in my trans & rear axle.
The gray one has been in the show before, but this was the first time seeing the red one. The gray one looks like a small block, and the red one...
my 72 mav has the flat blade contacts, and my 72 LTD has round contacts.
has any one done the mustang clutch pedal pivot shaft bearing up grade.
I am in the process of rollerizing my V8 z-bar and clutch linkage using off the shelf parts. If this works out I will do a tech article on the...
thanks :thumbs2:
need measurement on a v-8 z-bar what is the inside diameter of the holes in the ends of the z-bar. are they 1 inch?
Check your oil level
I replaced my equalizer bar bushings at the end of May 2009. Here it is only June 22 2009 and both bushings are shot. I used a kit from ebay like...
Got a little help on fathers day Pulling the engine and trans.
they need to be serviced?:hide:
i am looking for an alternative radio antenna to use on my 72 mav. there is not a factory hole in fender for an antenna, and i don't want to cut...
I would get at least an 18 footer. If you need to haul something bigger it's better to have more room than you need. this is my LTD on a 16...
nos one on ebay
why do some people feel the need to dog on the 289?
I used the cable from a 70 mustang with a 4 speed. then you need a left hand driver gear. to get the correct driven gear (the one on the end of...
Separate names with a comma.