Persistant Buyer I bought my Mav from California and had it shipped to me in Ohio last summer. On the day it was going to be delivered, I...
Does anyone know the part number for a single groove four bolt crank pulley to fit a 71 302 without A/C or PS? Through some internet research, I...
There isn't anything special about this tire. I am looking for this particular brand and size because I have a brand new set of 235/55/16 mounted...
It's a Yokohama YK420 225/50R16. Did the rain hold off long enough for you to get the steering parts off today? Did you get my PP payment?
I have been searching for a very specific brand and size of tire that is no longer produced and I found a set on craigslist in Columbia,SC. The...
I found the same plug in my trans last weekend. I just finished installing an original 302/C4 setup out of a 71 Maverick. I bought the entire...
Belly Bar Location I'm just finishing up the V8 swap in my 70 Mav and when I went to install the belly bar, I realized...
I'm in the final stages of the I6 to V8 swap in my 70 Maverick and I installed my newly acquired V8 throttle cable today. My question is....Do I...
The throttle cable from my I6 went around to the right side of the carb where it snapped into a mounting bracket and attached to the carb. Now...
OK, it looks like the tranny brace question has been cleared up for me. I pretty much thought that was going to be the answer, but I wanted to...
Yet another V8 swap post I am looking for advice from anyone on the forum that has completed a V8 swap in a 70 Maverick. I started the...
If I am doing the I6 to V8 swap in my 70 Maverick, do I need to change the drive shaft also? Is there a difference in drive shaft length between...
Pictures please:2thumbs:
Thanks for the pics. Is there any way you could post the part number listed on the back of the clock?
Thanks for the number Bob :tiphat:
Thanks for the idea. I would like to try to find an original cover or clock first before I fabricate something to fill the hole. If I have no luck...
I just purchased a factory consolette from another forum member, but the clock and/or block off plate is missing. Does anyone know the part...
Check this thread out for all the details: http://mmb.maverick.to/showthread.php?t=63717
There has been a lot of interest, but no one has pulled the trigger and placed an order yet. Hopefully, a few members will buy the panels and...
No, not yet. Still on the hunt for the door panel.
Separate names with a comma.
