AutoKrafters has them for less than $10. Just need to determine which one I need.
Ok, I checked the tooth count on the speedo gear and it's 19 teeth. Easy to get to. Raised the front of the car up a few inches and was able to...
Good deal. Thanks
So this gear swap is fairly easy? Any special tools?
I swapped it out to get a little better mileage. Plus I got the gears at a steal. I was needing to replace the seal and gasket anyways. I'll find...
I have the factory size 14's on mine. Just a little wider. When cruising at 60mph according to GPS, my speedometer is reading 54. Are the gears...
I've swapped out the 3.00 gears in the rearend for 2.79 and was wondering if there's a way to determine if I can change the gear for the...
After reading some of the reviews on my Cal Customs aluminum finned oil pan, several people had an issue with the leaking around the oil pan plug....
Those look good.
I have an oil leak and it seems to be around the oil pan plug washer. It's an aluminum finned pan and I think the washer is not sealing properly....
I contacted the mechanic and he told me he did not rebuild the converter. It was in good condition. When I get the maverick back next week after...
One thing to note...When installing the new 302, I was going to replace the motor mounts with new ones. However, the new ones had a fitment issue...
I talked to the mechanic and he's going to give it a good once over. He said he knows everything that would cause the vibration and how to find...
I recently had my c4 overhauled on my 73 Maverick 302 c4 and I noticed a vibration in the vehicle when revving the engine in park and also when...
Ok. Thanks rthomas.
I'm looking for a set of seat belts, (whole set including shoulder straps, lap and female ends) for my 73 Maverick 2-door with bench seat.) If...
That was the culprit. Here's the thing, I made sure the lines went back to the same position as was removed. The lines were crossed to begin with....
That was one of my thoughts, but thought for sure I had them lined up right for reinstall. I'll go swap them and try again. Is there a diagram...
I had replaced everything to do with the power steering in my 73 Mav 302, (hoses, power steering pump, power steering control unit,) except the...
I'm running an Edelbrock 600 on my 302(stock) and get several different answers on my question: I checked the vacuum and it shows around 14in. The...
Separate names with a comma.