Take a look at this video featured on Stangssite.com. It shows how weak the drop down bracket can be when used on the power steering on fords....
The electric motor unit installs in the steering column shaft under the dash. Just like most new cars these days that have electric steering. Yes...
Getting all the connections to seal could be a problem is the seats are deformed from all the years of use. New seats can be ordered to replace...
Can't say I agree with ford power steering having leaks or sloppy steering. But in the interest of simplifying my setup will be switching to...
Just crank the wheels back and forth to the end stops several times and that should bleed all the air out. Ron
Have seen one like that come with a 97 Volvo. Ron
I said if once already and Krazy Comet said the same thing. If there is vacuum on the hose that connects to the EGR valve when at idle then it is...
The EGR valve should only get vacuum when the throttle is above idle. If there is vacuum at the valve at idle someone has switched the source to...
If you need the plastic elbow for your pcv there are other pcv's at your local auto parts store that have the size you need. Just get the valve...
The 3g comes in large case and small case versions. Get the small case version and it will fit anywhere a 1g will fit. It's actually a little...
Upgrade to a 3g alt should solve your problem. They come in amp ratings well over 200 amps. And they will fit anywhere a 1g will. You can find...
From what I see in the pics either a BFH or some grinding on the shock tower where the room is needed would be all that needs to be done. Looks...
Even if the shock tower narrows down some at the lower level, doesn't seem like a major problem. Even with stock upper arms. If you did need a...
It it were mine I would just cut the reinforcing plate below where the UCA shaft needs to bolt on and just flatten that part to the shock tower....
Yes your engine will run just fine without an EGR. Environmentalists won't like you but since you don't have emissions testing no one will know....
I'm pretty sure you have identified the wires polarity correctly. And you have it right on how to connect them, To wire them in series the + of...
Years ago radios were 8 and 16 ohms impedance. There were some even more. some mid-70's fords were only 4 ohms. I have a 74 Mav radio and it is...
Good! Then they won't fail as in the video. I didn't weld mine but stiffened it up by extending the mounting surfaces and adding extra bolts and...
Crossing the ram hoses when hooking them back up is not only dangerous as well as allowing the wheels to flip back and forth rapidly could cause...
I had a set of dash bezels redone by CVVacumplater and they came out great. But cost was over $600 not including shipping. Depending on how many...
Separate names with a comma.