Here is the worst possible angle i could get in my garage... If it ran i would pull it out and find juuuust the right lighting and angle.. but...
Had to share this... Loving how these turned out. 235/60r-15 on the left and 255/60r15 on the right.. all on 15x7's. also i got the T5 back...
Basically... im using a makeshift hydraulic kit that i pieced together myself (mostly through rockauto)... im using a push style.. there's 2...
been working nights which gives me ALL DAY to work on the maverick! today I was able to... - get the slave cylinder and throwout bearing/clutch...
took my SN95 bellhousing into the shop and cut a hole in it for the slave cylinder for the clutch. also fabbed up a support brace to reinforce...
should work well, if it doesnt have a matching bellhousing then make sure you get the right one. the ones off the SN95 (late models) mustang are...
i had the carter yf on my mav when i had the original 200 in it. i never messed with it as i was young and didnt really know how to. I just...
thanks! let me know how it goes. im not sure the type of carb you have but many times you can change out the jets. you might just have a lean spot...
quick update... So after fighting with the timing and no matter where i placed it, the car just would not run on mild throttle, i decided to...
also it is the 91 HO firing order.
im 99% sure its on compression... ive already flipped it 180 a c0uple times trying to see if that was the issue but ill pull the plug and make...
Engine: 91 5.0L i replaced my distributor with a "ready to run" variant and thus deleted my duraspark ignition. i think i have the wiring correct...
also it could be leaking gase out of the inlet (where the fuel line screws into the carb). if thats the case just use some sealing plumbers tape...
I had a similar problem with a single barrel carb on a 200 ci. the needle would not set properly due to rust flakes from the gas tank. I always...
this is regarding the rear bumper correct?
thanks! just wanted to make sure the brackets lined up. figured they would but didnt wanna pull the trigger and be left with a dud...
i have an A servo on there. is that not enough do you think?
Is this possible? my 71 has a really beat up bumper and i found a 73 bumper available for purchase. It has the bump gueards but as long as the...
Thanks! ill check it out. Oops! i meant to say low power in that first sentence... i proof read it too :slap:
Thanks for the quick reply. I'll get the modulator tomorrow and I'll report back with what happens
Separate names with a comma.
