I've used the TransGo kit twice. :thumbs2:
A few notes: A 100% charged battery is typically 12.6V to 12.8V Charging voltage is higher than the battery voltage - typically 13.8V to 14V (Has...
Try not to scratch the surface with screwdriver, potential to leak through when new gasket seal is installed.
PS: I cut off the 90 degree mounting brackets plus some on the Derale , and then made a 90 degree piece out of aluminum to mount the cooler closer...
Much easier. BUT, if you don't use a 90 degree fitting (does not have to be a "AN" fitting), it may be difficult to wrestle the lines between the...
Looks good! :clap:
I used a Derale cooler, with threaded 90 degree 3/8" fittings to 3/8" braided lines. Mounted it in the center of the grill opening for maximum...
To guy who installed Weber carburetor: What size jets did you use? Thanks!
With copper lines (or any metal lines), be sure to put in plenty of "Strain Release" bends. This relieves tension and prohibits line from bending...
https://www.yahoo.com/news/ford-trademark-request-suggests-revival-131815324.html
Be careful when bending the "tab". Only bend the tab, not the whole arm.
Sounds good! :bananaman:
[ATTACH]
Perhaps it was a copy paste error. I think we're intelligent enough and forgiving to overlook. PS: did you know that the Valvoline company started...
Oil selection and lubricating qualities has nothing to do with cubic inch.
http://www.compcams.com/Products/CC-%27Lubricants%27-1.aspx
I had the same problem. Someone sent me this link: http://1bad6t.com/Maverick/maverick_50.html
Also, Digikey has MANY fuse clips & holders: https://www.digikey.com/products/en/circuit-protection/fuseholders/140
Yes, mounted on the connector on the box side. See attached diagrams.
Does anyone know if there is a Maverick club in Guadalajara, Mexico? Thanks!
Separate names with a comma.