Anyone have a C4 5Bolt Bell Hausing For Sale ?
This is what i have here, not sure the rearend is realy off center, may be where the upper fender was rolled..Im going do do some more measurments...
Yes, i installed the upr kit that makes it all stronger, for uppers & lowers..Was all bolt on..Someone told me to tighten the uppers but i still...
Well i have all new UPR upper & lower adj controll arms..Have all solid bushings...I just re-measured the arms earlier and they are dead on..I...
Anyone know why so many sn95 and the fox body also, the driver tire sits out more than the pass ? Some say they have seen it the other way..Mine...
All UPR...I bought the upper and lower plates that were welded in for both upper and lower's...And boxes were welded also..I have a yoke i use...
Its a 95 stang with front and mid motor plates..4 link all solid bushings..Anti Roll Bar I can not lower the trans because of the engine...
which is best to raise or lower pinion? Upper or lower control arms ?
It says different on this page i ran across earlier' http://www.wolferacecraft.com/pinionangle.aspx
Looking at the angle finder from the pass side, i have 1-1/2 to the left of 0' which is pinion down from what i can remember..I have 2-1/2 to the...
Will the C5 pump work ok in a C4...I have built alot of C4's but always layed the C5 pump aside...I noticed it already has the spring/balls...
Rear Servo I guess i misunderstood you...Was it the rear servo leaking ? IF so it has to be the square oring that goes underneath the servo cover...
Leak I have seen alot of the tci valve bodies blow them servo gaskets or cause them to leak...A good servo cover from Pa or other places will...
Your right! I just found out a friend of mine was suppose to have put 2 qt's of fluid in the converter like i told him but didnt..I ask him about...
This trans was only ran 20 mins or less...Onlything i can figure looks like bad casting flash in the pump saddle where the bushing sits' and it...
Separate names with a comma.
