This thread has posts I made a day or so after a points to Duraspark conversion on my 72. It has all the details that I would expect to see in a...
Welcome! :Welcome:
It was a loose wire on the transmission... :rolleyes:
I think if you add up all this expense for a 9" rear that is wider than a Maverick's rear, has disc brakes that were only used on one model of...
If you want to narrow the rear slightly to make it the same as a Maverick width, why not just narrow the housing and fill it with Maverick axles?...
You might think about converting the 9" to Crown Vic or Exploder rear discs. Like Dave pointed out, the discs on these are unique to a 30 year...
If it's not a 7.3, it's not a Powerstroke IMO... PSDs rule. IMO the I6 diesel sounds funny, and Dodge trucks are rattle traps. Again, my...
Thanks for the ideas guys. All I have tried so far is pulling the spout to make it fire, but no change. I have walked away from it for a bit to...
It's not a likely candidate for 'blowing up'. Rings are not usually a sudden failure thing, like bearings for example. It could die a slow...
Agree. I have seen synthetic oils AND things like Marvel Mystery unseat the rings. Seafoam may have the same effect??? The 5w30 "mistake" may...
Sounds like too much pressure in the case. That is usually compression escaping passed the rings/pistons. The valve seals will not cause oil...
Riddle me this... The E4OD tranny went out on my truck the other day, or so I thought. It has been running a little rough, then, turning a corner,...
I like the Mustang shaker on our cars, but I love the Torino shaker on our cars... ;) Another cool scoop is the old Dodge Demon twin snorkel....
If you decide to go coated, give Jet Hot a call. They are a Hooker dealer, and sell them new with their Jet Hot coating. It has been about 5...
Tubular sells Maverick specific 351w headers, but they are only 1.5" tubes. While not specific to a Maverick, Hooker's 1.75" 65 Mustang 351w swap...
The big help with drone is getting tailpipes ran out of the back of the car. (Unless it's a hatchback car)
Personally I believe it should be mounted by the fuel tank for many reasons, including making the noise a bit less. However, dad mounted his...
Are you going to run the exhaust out from under the car, or dump it underneath? My comment here would be that dumping under the car, or even...
Exhaust is an issue... They make headers for the swap, but I have heard Maverick 302 manifolds work on a 351w. If any iron manifolds were to...
We have a Holley blue on the Chebby. Originally we had the rubber gaskets between the mounting ring and body. That made the thing sound like a...
Separate names with a comma.
