Try using these spec's........... https://opentrackerracing.com/tech-info/ David
Find a shop that can check all your suspension components, upper/lower control arm bushings, spring perch bushings, tie rods, ball joints, shocks,...
https://deltabaymustangmaverick.com/ They had them made for our Mav/Comets, although maybe backordered, contact them to see if still available,...
Shelby Drop explained in simple terms.......... [MEDIA] David
Alignment spec's........ https://opentrackerracing.com/tech-info/ David
So long as 6 bolt pattern on block/bellhousings, 157 and 164 will bolt on........ David
No, there is no forward hole/nut location on our 73 (at least on my Comet) like on the 74 and up........ David If I recall, the "flattened" area...
Not a problem, when you are ready to tackle this, you can PM me if you run into an issue. It is really quite simple to do, if all you are doing...
Try contacting "Chip", he may still have fiberglass Comet hood........ http://mmb.maverick.to/threads/maverick-comet-parts-for-sale.116741/ David
Yes, you will have to separate/disassemble the column, definitely something you can do and since it is already out of the car, much easier! You...
Here are pictures of rubber seal that goes between the inner shaft/middle tube and foam seal between outer/middle tubes........ David [ATTACH]...
Are you referring to the rubber seal/foam rings? I doubt that they are still available, from your pictures, it looks like you are missing the...
There actually is a rubber seal between the inner shaft/middle tube and a "foam" ring between the outer/middle tubes, but after 50 years, it is...
On the OEM shaft, there is no bushing/bearing on the lower part, only the upper shaft has a bearing (which is still available), the lower shaft is...
Walt sent me a video, but it is .mov format which this site is unable to accept, so have to figure out how to get around this.......... David
With them on my Comet, I just have to be on the corner, lift the hood slightly to pull the pin (updated design, push the hook/lock back) and hood...
No, you still have to manually (lift the hood slightly) push the "hook/lock" back when lowering the hood, if a gust of wind does come along and...
Walter Federline has upgraded his Billet Aluminum Hood Hinges for our Mav/Comet with a better locking system, check them out....
[ATTACH] Here are pictures of my 71 Comet GT rear housing/axles, that housing is 51.25", however some people have said theirs where 51.50", so?...
The cut out is still the same for manual, still can use the measurements from the picture, otherwise marking from underneath will definitely get...
Separate names with a comma.
