8v at +coil during cranking, If I pull the connector on the Dura Spark coming from the ignition, I then get 12v at the + coil with key on. I...
Okay, I just when back out in the garage to check it and it started twice but not on the third try. Only 5 volts at the coil?? The test light...
I pulled the ignition switch, pulled it apart,visually checked the contacts and re-installed it. Measured the voltage with key on, 12 volts...
The 70 Mav and 72 Comet have been in the garage most of the past 3 years. I start them regularly and actually took the Mav out for a couple of...
Move Post I should probably re enter this post in the Tech Forem.
Hi Everybody, I'm not actually a new member. It's been a couple, three years since I've been on. Been busy working and building a new house. I...
Adjusted the clutch and linkage and still grinding. Looks like I'll have to pull and take it to a tranny shop. Anyone know what I should expect to...
They look like caltrac bars. Down at the bottom of the thread page there is a set of plans for them provided by 71 Gold. Looks like I can do...
My next investment is going to be leaf springs and than traction bars. Hoping to cure a bad weel hop. What's the best deal for the money?
Just installed a top loader from a 68 Mustang. It came with a hurst shifter. If I try to shift quickiy between 1st and second it's very stiff and...
I 'm hoping there is a gear in there. I'm going to check in the morning. I was under the impression I would have to change it but it looks like...
dm. Man you are good! Thanks
If you can't tell, my knowledge on this subject is very limited. How do you remove the drive gear from the tranny. Don't tell me I have to takethe...
Thanks dm
They did have a reverse gear avaiable in DKTT's that ingages the reverse gear??? Checking your speed in reverse? The port is on the other side.
Went to DKTT's website and found that I need a 7 tooth drive gear but it looks like I have choises of a 16 thru 21 tooth driven gear. I'll call...
I probably need both. I just bought a junker cable because the old speedo cable that came off my 3 speed was a couple inches short. I don't have...
I need a new gear for my Mav's top loader. The local Ford wrecking yard told me toploader speedo gears are reverse of the others. Anybody know if...
Separate names with a comma.
