I have found from another site that the S10 tail shaft has a 17 degree tilt built into the tranny mount with the drive side lower than the pass...
I am using a T5 & bell housing that came out of a 1995 Mustang. I swapped out the tail housing with a mechanical speedo S10. As you can see with...
Anyone running 99-01 Mustang Dual Piston PBR calipers on Maverick's Spindle ? Is there a noticeable improvement in braking over the stock...
Call me cheap but the SN95 V6 Mustang looks ok to me. I see them all of the time for $100 for set of 4 on Craigslist. My car has disk brake...
Here is a pic and size of the outer tie rods for Maverick/Granada vs. Cavalier. Oh yeh, I used some left over Explorer 5.0 Motor Mount Plates...
Here is the pics pics of the ZF rack. Looks like a very nice unit with all banjo fittings, all aluminum and no steel tube that rust out! The...
Dave, My 64 Falcon's engine bay is very tight. Therefore, I put the engine in with headers and then I made my brackets. I am planning to...
Dave, I scrapped the idea of using the Civic's Rack due to too much line interference. I was able to exchange it with a Cavalier's Rack at...
Here are the tie rods.
The Civic's rack is about 35" with the rack in the center. It has 2.75 turns lock to lock and travel is 5-3/8". I laid the Falcon's and Civic's...
The Honda Civic has 2.75 turns lock to lock. The rack travel is 5-3/8". What is the lock to lock turns on the Cavalier Rack? What is the travel?...
He is pics of my 2002 Civic Rack that I may use in my 64 Falcon.
This is Waid. I posted the electric steer info on the Mustang's forums. The guys over at the Ford Falcon Network are making a lot more progress...
I have two steering boxes that came out of Maverick. They are SMA-Y and SMA-F1. What are the ratio's and which one is the manual and which one...
Well, it turned out to be the 200 ! :(
I dont know anything about C4 but would this be good one rebuild for performance? Thanks [IMG]
I just posted a pic of the VIN. By the way, this car had disk brakes too! Besides the starter, is there anything that would let me know which...
I found a C4 in a 1975 Maverick. According to the VIN, I think it should have a 302 but it has an Inline-6. Not sure if it is 200 or the 250....
Well, here it is or what's left of it. I paid $10. I called a local drive shaft shop and was told they can take both weld yokes off and weld...
babdad457, I do understand what you are saying regarding center to center dimensions. I will not know that until I have the T5 & the 8" read end...
Separate names with a comma.