This was for a 200 CI setup. From the looks of the table, my suspicions are now confirmed. I will check mine tomorrow and measure. Right now it is...
That is what I am trying to find out. If I can get the stock length from a Maverick and compare it to the one I have from the Fairmont, I might be...
Anyone that has a throttle cable from a Maverick/Comet, would you please measure very accurately the total length from tip to tip and report back....
!) I have a set of engine mounts from a 250 and 200. These are the metal type attached to the block. One set shows L 250 and R 250. The other set...
Please ID these frame mounts: D5BA 6061 D5BA 6037 Are these for a 200 or 250 or are they the same?
Anyone out there have a diagram of the shifter assembly for a 3.03? I need to see how the rods and levers were attached as per the factory.
If yours is a 200, there are 6 bolts that attach the flexplate to the crank. They will back out and cause rattling. I always use red loctite and...
Anyone the original parts diagram and/or instruction sheet for the Hurst Competition Dual Loc Shifter for the 3.03 3 speed? I need to see the...
There have been a few Mexican 302 blocks for sale lately here in Phoenix over the last year or so. Of course we are very close to the border so...
Has anyone tried successfully to disassemble and clean the seat tracks for Mavs and Comets? Step by step instructions would be helpful.
Crossposted from TFFN http://jkgraphics.com/Eagle/images/Power_Windows.wmv
Cross posted from TFFN Click on the pic for the video http://growingbolder.com/media/technology/vehicles/romancing-the-road-259598.html
A 250 crank will not fit but I am now suspecting that someone played around with the engine. It is possible that 250 caps were installed but that...
I opened up my 200 because the flywheel would not rotate fully and was stopping after 210 degrees of rotation. After removing everything relative,...
Does anyone know of a car that had integral seat and shoulder belts built in. I do know the Sebring had those and was wondering if any Mustangs or...
I just got off of the phone with Dennis at CSRP and he nixed the possibility of a 4 lug setup. He did state that there were some 4 lug rotors that...
Well, this all started some time ago when CSRP started doing disc brake retrofits for the Falcon, Comets and early Mustangs with 4 lug. I emailed...
After re-doing my rear brakes on my 4 lug 8" rear, I noticed the brakes are very narrow. Any ideas on how to make some mods so I can use wider...
I just looked up the front bearing sizes for the 4 lug and 5 lug spindles on Rock Auito. They show the bearings to be identical for my 72 Grabber....
Has anyone put disc brakes on the front of a 4 lug? If so, what parts did you use?
Separate names with a comma.
