I was thinking something along those lines. Might need to do both (tub and flare) to get a really big tire though. The tub guys I am assuming...
Hey guys, been enjoying my car for a while now, but I am ready to have a bigger tire. I want 315s or bigger. What have you guys done?
the detonation at 200 degrees is a little suspicious. 200 degrees is by no means overheating, most modern cars run at 200+ as normal operating...
I drive a 388w dart block with the same radiator and a cheap ass Amazon fan and it doesn’t overheat. Your original total timing sounds a little...
so if the vacuum hose is left completely disconnected (I am assuming you don’t plug it when you take it off the PCV) the car runs great? Sounds...
Anybody know of any SN95 drop spindles? When I bought my AJE K member nobody ever mentioned how tall the front ends up sitting. I have the 175...
Well guys I am doing a rare thing here, giving you an update: the Maverick runs like a champ and my carburetor problems have been fixed. There...
Good news guys, put the 8.5 valve in and it is much cleaner at part throttle, AFR starts at 13.5 and falls to 12.5 and stays around there. I...
This might sound dumb, but would scavenging affect carburetor signal dramatically? I do run full length smallish diameter headers (1 5/8) and a...
I have considered that I might have a vacuum leak, but in my opinion that normally requires a much bigger primary jet and idle screws backed out...
No problem at cruise, it had a stumble if I punched the gas let's say from 5% throttle to 30% throttle, the bigger pump and cam cured that. The...
Would be helpful if you suggested what the other problems might be. The 50cc pump does seem big, I did run my previous engine (milder 331) with...
T slot woes are not fun, I ordered a Brawler carb for this car a few weeks ago and it looks like Quickfuel moved the t slot up a little so you can...
Took it for a spin with the vacuum gauge attached, cruise is between 12.5 and 17.5 depending in how cracked the butterflies are. My lean spot is...
I'll order an 8.5 and a 7.5 and try them out. Will get a vacuum gauge from HF tomorrow and see what I get at cruise too. This carburetor and...
Yes. I just can't imagine it needing a higher numbered power valve. I am using the 6.5 now...maybe I should drill the fuel passages? The car...
Hey guys, trying to get the tune just right on my Holley carb. Let me tell you what I have so far...388w with afr185 heads and a 238 degree cam...
Is the 2 door hood the same as the 4 door hood? Also, heater core/evaporator any different for 2 door vs 4 door models? Looking to pick up a 73...
I think one issue he is having is the fact that he is using a flat tappet cam, a roller would allow him to use some more aggressive ramps and...
I used a flat tappet cam with that spring kit on my F100 with a small summit K3600 cam, I wish I had gone bigger, but it is getting a turbo so I...
Separate names with a comma.