Sadly,(well not too sadly) I sold it... Guy made me an offer I had to take... I will miss it,but it went to a good home... Guy has it in his “man...
[ATTACH] [ATTACH] [ATTACH] Drove it a little over 1100 miles in the past 7 days... Had to go up to the foothills of the smokies to check on a...
Well, I got the tv cable set... I did,with an oil pressure gauge,and reading the instructions with the Lokar kit... Shifts like it’s supposed...
Took it back to the transmission shop(use that term loosely)yesterday morning,they assured me that they would get it right... Got it back today......
Got it back from the transmission shop today, $1700 later,still has a bad AOD transmission... When I took it in,it had 1st and 2nd... Now the...
Well,got some of it figured out... Transmission was the source of vibration... Think the rear bushings are worn out,theres still rubber there but...
Yeah,was trying to get an idea on one... Rear spring side loading causes goofy driving,need to keep it from "dogtracking"...
I tried looking it up,but can't seem to find it,has anyone installed a track bar for the rear? Not ladder bars,but the ones to keep the axle...
One of the cars I learned to drive in was a chevette... You had to turn the air off to accelerate from stop... Semi trucks would be upset because...
I'll remember that... Kinda like Raybestos parts,never had any bad ones... Car I pulled this stuff off had just had pads and caliper,so I just...
I generally check fluids,get a hot battery,see if it will crank over,pull the coil wire from the cap and get it about 3/8 from the engine block or...
I know this post is old,but mine has "Air Condition-Manual"... I manually roll down both windows :rofl2:
Got mine from rockauto... Shipping was the pain,$125... Local glass shops couldn't come up with anything,some never called back... None would...
69 mustang in mine also... Write up on here about it... Was cheaper than a Mav tank,and less than the local radiator shop wanted to coat a...
Really good distributor and ignition,I've put 2 in mine so far... Butt-o-meter says the second is the best... Belt and pulley system will free up...
Hello from south Alabama! Really great folks on this forum,though I haven't met them personally,far and away the best bunch... Like said...
They didn’t give any... Either time... The short block is 91 mustang/thunderchicken 5.0 HO,164 tooth 50 oz. flexplate,balancer is the same...
Would like to pick your brains a little if I may... Couple questions,(1)I rebuilt the front suspension on the 72,all new components,upper ball...
Finally got the heads back on... The mav had been suffering from low vacuum,low power,excessive fuel consumption,so tore the top end down,and it...
I'm not liking the pads I have on,they dust alot,so when i get ahead of the bills,i'll tear it down... You don't have to take them off to change...
Separate names with a comma.