I'm crushed. I felt like Indiana Jones for a minute.
I think that the mythical Maverick is up for auction on Auto trader classics....
When I installed the dash, I enlarged the screw holes in the firewall flange to allow the screws to slip through. Then I put clip nuts on the...
Hi Satchelmcqueen. I find it much easier to install the eng/trans with the rear of the car raised and secured, and without the harmonic damper...
Yes... I'm a little muddled right now. And thanks again everyone for your input. The last possibility I thought was a small vac leak at each...
Do you believe the problem is in the primary side? Or is it in the secondary side ? How would I troubleshoot this down to the component ?
Plan b sounds good. Pardon my ignorance but what exactly is plan b ? Keep in mind that I am not wanting to do an LS swap at this time. I am...
Hi Frank, I'm pretty sure ( 70 to 80 % ) that there are no holes or cracks. I think I would have seen something like that while prepping for...
I think I am down to swapping the manifold. I didn't pressure or vac test it yesterday because I decided to set the advance curve on the procomp...
Do I understand that the vac test is for checking valve seal ? I thought that the cranking compression and leak down tests had ruled out valve...
I've leak down tested each cylinder. I can't find the results right now but they were all well within tolerance. I've never heard of a vacuum...
Hmm... I have other manifolds. I am thinking about closing all the intake valves and smoke testing the manifold that way. I can't find where...
It is a used manifold. It looked almost new . It was bolted onto something but i don't think it ever had gas through it. That doesn't mean it...
The manifold gaskets were another thing that I used because I had them. They were unbranded but I thought they looked like good gaskets. I've been...
I used a 4 hole gasket that came with the Mr gasket heat shield between the carb and the 4 hole shield and an open gasket between the shield and...
Yes i have the 80570 except the power valve is the 6.5 now. It is the factory HO cam. The secondaries are closed as far as they can go without...
Thank you rthomas771, It looks like lots of folks have used these coils with duraspark. Some with , some without the ballast. Thank you...
I've never used an e coil with the duraspark before. It never occurred to me that it might be incompatible. I'll do some research. The coil is 1...
Thanks groberts101. It's the 4150 model and has the original main jets and no mods to the air bleeds. Now that you mention it. There is a...
Thank you, Tom and Hotrock. I got the carb and manifold both used but in like new condition. I rebuilt the carb like I always do with a used one....
Separate names with a comma.