Had the same problem on my 302 before my engine change. Module would even test good at AZ, but a change to a new one cured it. Good luck.
Hot Rod magazine showed a '69 factory test mule that even had thermactor emissions, so FoMoCo built at least one to test. Let's clear up that in...
Just FYI, 6 speed and aluminum driveshaft out of a '03-'04 Cobra fits w/o mods. Only need crossmember mods and adapting rear u-joint. C6 and same...
The Boss 351 Mustang was produced in 1971. It featured 11.7 to 1 compression, 4 bolt main block tested for hardness/durability..the crankshaft...
Great pictures of the cars! I have only peviously seen louvers for a Maverick on the green Mexican Shelby show car. Did you make the louvers, or...
A higher octane fuel "slows" the speed of the explosion of the fuel, and lowers the heat in the chamber. If you are in great tune and drive...
224 at .050. 270 advertised, 110 lobe seperation. Keith Black pistons are a very durable, tight fitting design. Don't put in the lowest tension...
Power steering adds issues with headers, so manual steering helps. I had gained clearance by using TRW muscle motor mounts for a '70 Mustang that...
Thank you for the responses. As soon as I figure how to post a picture, I will have them up. I had to build a Boss 351 Maverick to feel I had the...
Any other Cleveland powered cars on the forum?
After owning many cars over the years, my passion is still for the Maverick now, just as it was 25 years ago when I bought my first of 4 Mavericks...
Separate names with a comma.
