Do you have any pictures of this setup with the tire off?
Dave, can you go into detail on what the engine was doing when you said it was running like crap when you get on it. Does it run strong up to a...
Yes, put me down for 2 and a possible. 2 for both of the 74's were covnerting and possibly one to replace the painted one on the drag car.
I would check the battey and do as stated above. Also have your recently switched from points to electronic ignition? if you have i think you only...
Scott, Thanks for the pictures. Before you modified your lips how close were they to your tires? The Blue looks very good on your car btw. Cam.
Scott, do you have any larger pictures of your car with these on? And what rim/rear axle combo are you using? Thanks Cam
What is the tallest and widest rear tires anyone has had luck fitting on the mav with 14 or 15 in rims? Pictures would be great. We ran 14" rims...
has anyone ordered any of his videos? Looks like a lot of home made step by step how to videos on Ford power train systems. If so how satisfied...
Found another 74 6cyl mav and comet. Mav is very solid but motor is out, the comet is a parts car only as it is wrecked in the side and heavily...
thanks for all of the suggestions. I have checked the battery when hot and it is ok. I probably will go ahead and replace the relay just because...
for some clarification. The starter will not turn when the car is hot and the headlights are on. I can jump across the starter relay and crank...
The 74 started doing something strange the last time i drove it. When it got hot it would not crank over with the headlights on. I can let it...
I have only had experience with an cheap harbor freight 120v one. It is very heavy and awkward compared to an air gun but it beats ratcheting any...
if the fuel pump, carb and filter are all OK, then check the see if the rubber hoses between the engine and tank are collapsing:huh: .
If you have some time you can modify your column shifter bracket to make it work with the hookers. I started modifying the one i had this past...
Boil it in water and drive it on with a block of wood infront of it. Here are instructions from FRPP....
Yea, that is what i did. I did that before i decided to drill the hole. I have put on a fexplate or two and know they do align only one way when...
and the famous saying goes........."There i was" flex plate in one hand Drill in the other. It all seemed so clear to me then. "fix" this hole...
didn't mean to upset you by what i said. I read the board alot and see you post to almost everyting. When i was typing the post i was...
I knew i could count on you to answer even if no one else did. I purchased a Hays flexplate from jegs and i have played Wheel of Fortune on it...
Separate names with a comma.
