Any head studs/nuts loose when you tore it back down? Where exactly is it popping the gasket? Im wondering if the gaskets expanded and...
I was thining,,,, and stand back,,,, things gonna explode,, LMAO!!! I considered the AOD, but the transmssion tunnel was the small shaped...
JD71,,, Ill get you some pictures of my serpentine belt setup in a day or two,,, my computer crashed,, lost over 1000 pictures of my progress on...
Baddad, Ill let ya know... LOL!!! I had about 3 gallons in the tank,, Im suspecting a 5 lb bag. it didnt run long,,, long enough to plug it all...
When it dries a little in open air, it reforms into a jelly like substance, and its sweet to the taste, when its fully dry its hard like a...
Went to take the maverick for a spin, fired it up ran good for about 5 minutes and died and wouldnt restart. Took the fuel filter off, had sugar...
Scoop, are you running a roller cam? is it the stock roller or a high performance? Mine has the stock roller cam with a 2 barrel motorcraft...
Put a vacuum guage on it. If you have a big carb, you may not have enough vacuum to maintain a constant pull on the carb's venturi which means...
JD71,, I used the stock late model alternator and the bracket, which also holds the tension pulley. Its in its stock location on the right side of...
If you get a EFI engine, you basicly strip it down to the block and heads and then retro fit the older parts to the newer 302. (manifold,...
Add a resistor to the power wire going to the coil, this will help make the coil last longer. Too much voltage going to the coil will overwork...
Hey JD71,,, I have a complete Speed density EFI setup with a custom built harness minus the fuel pump for sale if your interested. I built the...
When I built my EFI conversion, I had a complete engine, 1988 model, which is a speed density system. I took a factory harness, cut all the plugs...
I didnt drill it, figured it would void my warranty. I got the brakess adjusted, working very well and very happy to get it to stop! The drums...
The long block is out of a 88 t-bird sport. Had a AOD behind it, When I got it, the fuel pump died in the t-bird, So Those being salty, I put on a...
All cyls have exactly 150psi. Been thinking of a new timing chain set. I had the heads off it a while back, cleaned,, cleaned, new head gaskets,...
Does 22 inches of vacuum seem high for an idle reading? 88 roller cam 5.0, with a 2 barrel motorcraft. Bone stock. Gets plenty of fuel, has a...
Wakasha gas 6 cyl. Stock stroke is 4 inch, Bore is now 4 inch, with a 2-5/16 compression height and a 1.25 diameter pin. Thats with stock stroke....
Good Morning! Cold outside and the maverick is full of antifreeze! I need some help,,,, Im building a stroker engine, and cant find any specs on a...
I d look at a GM throtle body,,,, make an adapter plate to an older 4 cyl manifold that had a 2 barrel carb. Something is bound to come close,,,,...
Separate names with a comma.
