Headers For Mavs W/351w Found

Discussion in 'Technical' started by oddball25, Dec 20, 2002.

  1. oddball25

    oddball25 New Member

    Joined:
    Dec 16, 2002
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Williamsburg, VA
    Vehicle:
    70 maverick grabber
    I was looking on AUTOKRAFTERS.com last night and found headers for 70-77 mav's with 351w swaps!!! They are PRT# ES9 and run about $350.00. If you go to their site you have to browse under "ENGINE" and then under "EXHAUST". They also carry a few more headers for 302's and I-6's. :D L8Rs
     
    oddball25, Dec 20, 2002
    #1
  2. mavman

    mavman Member

    Joined:
    Mar 9, 2002
    Messages:
    2,028
    Likes Received:
    13
    Trophy Points:
    112
    Location:
    Arkansas
    Vehicle:
    '75 Maverick, '03 super duty, '04 Mustang Vee-six!
    yes, I saw them last year when searcing for them. They are 1 1/2" primary tubes, which would be ok for mild 351's, but could become a choke point for anything else. As most of you on the board know, I ended up building my own custom headers--1 3/4x38-40 3" collector.
     
    mavman, Dec 22, 2002
    #2
  3. HWeiss

    HWeiss Member

    Joined:
    Aug 18, 2002
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Kalona Ia.
    Vehicle:
    1970 Maverick
    headers

    I just bought a set of Mac 1-3/4 headers for a 351 in a 65-66 mustang,they are long tubes.Have not tried them yet hope they work.:) That ES part no. that was listed earlier is a Tubular Automotive part no.Just FYI. Herb.
     
    HWeiss, Dec 22, 2002
    #3

Share This Page