Up for trade

Discussion in 'Maverick/Comet Projects' started by Bob Wiken, Nov 2, 2010.

  1. Bob Wiken

    Bob Wiken Chronologically Gifted

    Joined:
    May 10, 2007
    Messages:
    1,592
    Likes Received:
    4
    Trophy Points:
    102
    Location:
    Fayetteville, Arkansas
    Vehicle:
    1973 maverick, '87 306 H.O., roller rockers C4
    I have just discovered the steel gear on the distrib I got, will not fit the shaft of the distrib i am going to use. The distrib is from an '87 roller motor E4ZE-12131AA. The shaft is .534 inches.

    The steel gear I need is for a C9CF-13161A distrib and needs to be .475"
    I will trade the whole E4ZE for the gear that will fit my distrib.
    That is about the last thing i need to get my new motor going. The builder said it would be ready tomorrow
    Thanks
     
    Bob Wiken, Nov 2, 2010
    #1
  2. franktf

    franktf Member

    Joined:
    Nov 12, 2009
    Messages:
    4,119
    Likes Received:
    336
    Trophy Points:
    206
    Garage:
    1
    Location:
    Pinellas Park, FL
    Vehicle:
    72 Mercury Comet
    This would probably get better response in the classifieds.....
     
    franktf, Nov 3, 2010
    #2
  3. Bob Wiken

    Bob Wiken Chronologically Gifted

    Joined:
    May 10, 2007
    Messages:
    1,592
    Likes Received:
    4
    Trophy Points:
    102
    Location:
    Fayetteville, Arkansas
    Vehicle:
    1973 maverick, '87 306 H.O., roller rockers C4
    How do I get to the classifides?
    Does any one have one to sell?
     
    Bob Wiken, Nov 4, 2010
    #3
  4. Bryant

    Bryant forgot more than learned

    Joined:
    Aug 7, 2007
    Messages:
    6,538
    Likes Received:
    153
    Trophy Points:
    203
    Garage:
    1
    Location:
    San Diego
    Vehicle:
    71 Maverick
    the gear you have is very common. the gear your looking for is not common. i hope someone can help you but i wouldnt count on it.
     
    Bryant, Nov 4, 2010
    #4

Share This Page