So we just did the V8 swap and now we need the correct pulley set up to run the alternator and water pump. Any suggestions? Thanks, Don
[ame="http://www.amazon.com/gp/aw/d/B005OKOLHE/ref=mp_s_a_1_1?qid=1404089539&sr=8-1"]Small Block Ford Pulley Kit,289, 302, 351W, 351C V-Belt:Amazon:Automotive[/ame] This is the kit I used, but it has a 2 groove crank pulley just in case I decide to run power steering,the same company has a kit without power steering. The finish is perfect and they're cheaper than March but still stings a little to pay so much for 3 pulleys
We ended up ordering a set of pulleys from CVF Racing. I will post a picture once they are installed.
Finally got around to taking some picures. Pulleys fit perfectly and so did the new aluminum Champion radiator we got from Jegs. Radiator was a straight bolt in....
Get a set of standard issue 5.0 (pre '94) under drive pullies and redrill the water pump pulley to match. The number on my belt is 6PK0990 390K6. Sorry, I dont remember the manufacturer. Been running this for a lot of years and have never thrown one off, even when racing up to 6500RPM.
http://www.cvfracing.com/Ford-Small-Block-Pulley-Kit-Alt-4-Bolt-Crank-p/sbfl1kit.htm Had no problems and they even called me back when I asked if I was ordering the correct kit