Pulley set up for non power V8

So we just did the V8 swap and now we need the correct pulley set up to run the alternator and water pump. Any suggestions?

Thanks, Don

 

post a want ad in the classifieds or buy an aftermarket pulley kit like the ones from march

 

[ame="http://www.amazon.com/gp/aw/d/B005OKOLHE/ref=mp_s_a_1_1?qid=1404089539&sr=8-1"]Small Block Ford Pulley Kit,289, 302, 351W, 351C V-Belt:Amazon:Automotive[/ame]

This is the kit I used, but it has a 2 groove crank pulley just in case I decide to run power steering,the same company has a kit without power steering. The finish is perfect and they're cheaper than March but still stings a little to pay so much for 3 pulleys

 

I just did a serpentine set up, I like the way it looks

 

I bought a set of aluminum pulleys off ebay. Don't recall the seller though

 

We ended up ordering a set of pulleys from CVF Racing. I will post a picture once they are installed.

 

That's where I got mine. Great to work with!

Older pic of when tested the fit...

 

Finally got around to taking some picures. Pulleys fit perfectly and so did the new aluminum Champion radiator we got from Jegs. Radiator was a straight bolt in....

 

Get a set of standard issue 5.0 (pre '94) under drive pullies and redrill the water pump pulley to match. The number on my belt is 6PK0990 390K6. Sorry, I dont remember the manufacturer. Been running this for a lot of years and have never thrown one off, even when racing up to 6500RPM.

 

Can I get a link? Maybe part #s?

 

http://www.cvfracing.com/Ford-Small-Block-Pulley-Kit-Alt-4-Bolt-Crank-p/sbfl1kit.htm

Had no problems and they even called me back when I asked if I was ordering the correct kit

 

Thanks!