Buy the length you need bottom the studs out that way when you remove the valve covers the stud will stay in the head
parts # F6TZ-9B076-AA vapor valve seal
E7DZ-9B593 vapor valve
E1AZ-9072-B filler neck seal All parts are available on amazon that is where I...
F30 spectra tank , Ford seals , Ford vent all bought on amazon
I did the same thing 71 gold did . In the future I am going with a 134 evaporator
I went with the stock Granada front disc setup and a ABS power booster unit for ABS power brake in Orange Ca.
You get it setup I will be there and will bring my son with his car... Jay
William I have a small number (2 or 3 ) of the ford intermittent wiper boxes with switch ... The boxes I have tested and have tested good but...
What ever length you need check with Coleman Racing Products they have both steel and aluminum shaft with u joints
will save you big bucks
If yellow can out reuse the yellow one
Nice job ... I did almost the same thing only on a 8" rear end made my caliper support for mustang caliper and Toyota rotors this all before the...
You are going to need find TDC .. The way I have to due it Remove the #1 spark plug bump engine over with your thumb in spark plug hole until air...
My new fuel tank sending for my 71 that I just bought from autokrafters is a 3/8"line
Thanks to Dave (55 crownvic ) got my gas hood struts installed ..
As much as possible... If you are going the EFI route then everything from the ECM, wiring harness . remove the charging harness from the head...
Bush are you able to bleed the rear brakes and get a good stream out of both side at the same rate of flow ???? If not take and remove both hard...
After all the engine mods I have done on my EFI 5.0 . Using a chip from one of the Mustang suppliers witch got it running BUT not very good ....
They use a acorn style speed nut
Next you drive remove your gas cap
If none of your contact can help you I have all the confidence that Michael at EFI dyno tune can
How about this gas cap
Separate names with a comma.