I guess I'm lost on why anyone would stroke a 302 to 347. If you want to lighter block but more power why not turbo? Or am I missing completely...
Well I REALLY had my heart set on a 351 small block. But as my luck would have it, I was given a complete 302 minus oil pan, distrib, starter....
Started wire brushing the floorpans from the inside. Got a little rust protective primer sprayed onto the parts I cleaned.
So if I get a 1970 mustang pan the contours should line up with my 1970 maverick? I dont mean contours like edges that butt against the rocker...
The torque boxes look fine. Ill.make sure todo one side at a time. Hey mavman what did you use to patch those big portions of floorpan? I noticed...
Congrats dude. I hope my maverick looks half as good as that when I'm done.
Hood finally removed took off that stupid latch assembly. Not too bad in the bay.
I hate to ask a newb question but where the hell are they located? In the rear all I see is the subframe wrap up behind the back seats into the...
That's good news. I really didn't want to mess with it. I'm gonna try to get all that crap cut out this week then so I can have it as ready as...
The passenger side is in the best shape two or three holes no bigger than a baseball roughly all located under where the front seat would sit. The...
I think I'm gonna take the safe route and brace my car for the floor pan patching I will have to do. Where is the best place to brace the frame?...
The problem is not how to move the hood without damaging anything. The problem is that the hood latch is stuck. The release will move up and down...
Removed front and back seats headliner and whatnot. Glad to finally get some progress done with my car. With the heat and all. I think next ill be...
This x10......
Moved my mav with the help of a friend to a concrete pad to start cleaning out the inside. Found a dead bird. Gross. Stuck on how to remove the...
Ok so my question is has anyone had success with a mustang floor pan to patch a 1970 mav? The floor pan patch is not going to have to line up...
That's a tight fit either way, it looks. I will probably go with the Windsor since it looks to have a little better clearance. I'm trying my best...
Its up in the air. I am strapped for project cash plus i am far from engine worries I think. I have to finish up with a head gasket replacement on...
Southern Illinois, near Mt. Vernon. And to mav1970.. eeeh kinda. I really want to put a 351 in with a four barrel. But i understand that tower...
Howdy. I just signed up here because I have a 70 mav that I'm going to fix up for a daily driver. It seems clear to me that I am going to need...
Separate names with a comma.