Beware of welding things to the axle housing. Unless done properly with a housing jig I can "almost" guarantee the housing will be warped using...
You may be able to swap the axles and brakes onto your stock maverick 8" rear housing. My buddy in N. Carolina would probably give you a good deal...
You didn't do bad for what you got for $700. I would not run the F4B because there are plenty of intakes that perform a whole lot better. The F4B...
My comment came off a bit harsh and I'm sorry for that. People have bought the patriot heads thinking its a bargain. Then they end up replacing...
Patriot heads are chinese castings with inferior parts and even worse machine work. Sorry but they're junk.
The tank is a thing if beauty, a work of art!
you can also slip a piece of rubber hose over the shaft that contacts the springs.
No reason to be sorry, you just spent hours to answer questions for people on the internet!
Ok, I never heard it referred to as a kit.
MSmith, what is n AFR kit?
Groberts, one thing I can't wrap my mind around is why connect the vacuum advance to manifold vacuum. The vacuum and also the advance just going...
Is your 9 pack in a box or blister pack? The only 9 packs my walmart has are blister packs. I still have yet to see any maverick at my local Walmart.
Shorty, it looks like you may have the wrong clutch fork. It looks too long.
The hood is huge!
Timing is a very important part of the tune. I'm sure this is why groberts101 was asking. You can experiment with that also. To an extent the more...
I still think you would be fine with the 6.5. It will come in a little quicker for better throttle response.
Of the power valves you have I would choose the 6.5. Adjust your carb for highest vacuum with the car in gear, sorry I should have said that before.
I thought that too unil I found out otherwise. The bearing size may be the same but the bolt pattern is definitely different. Bryant, while I...
No, not the old Torino style big ends. The explorer brakes fit the new style big ends that Lzoesch has.
Use a vacuum gauge connected to intake vacuum source and adjust mixture screws for highest vacuum while also adjusting idle speed screw (on the...
Separate names with a comma.
