the low stripe does give a odd look to the height proportions. i have always though a stripe that starts going up at about 1 or 2 inchs from the...
im thinking you have a valve problem. do a compression test. that should tell you if you have a valve problem and where it is.
chances are your starting system is pulling too much amperage, causing the solenoid to burn it contacts. it could be too much resistance in any of...
i think the factory floor shifter also has hump that is added to the tunnel to mount the shifter to. ive installed lots of aftermarket shifters in...
it only had a speedo and a gas gauge and it would have been difficult to fit around the cage. it was also heavier than the new one that is aluminum.
heres pics of the dash i did in my car [IMG] [IMG] i dont have any newer pics of when it was fully completed but it was definitely not silly
i dont want to but the original poster might. why do you ask?
you can get a reverse rotation flex fan that will work with the reverse rotation water pump.
i wouldnt use it. if the fuel pump can not feed enough for the nitrous then you will melt pistons. so a cheap pump can mean a expensive engine...
im wondering if you have a bad spark plug or wire. the quick way i check for this is to take a squirt bottle and spray each header tube while the...
you could tig weld an aluminum elbow on it.
they are great. i plan on getting a set when i get around to doing my rear leafs. they are around 10 lbs where the stock ones are around 40.
also what you have done is richened up the carb to compensate for a vacuum leak then fixed or reduced the leak and need to back on the carb
it sounds like things are pretty out of control with your cars tune at this point. usually a back fire out of a carb is from the motor being to...
what does the fuel pressure rise to when the motor is turned off? at what pressure does it start coming out of the carb?
the 8.8 is not even in the same class as a 8". a 31 spline 8.8 in a maverick will be strong enough for around 700 hp. the 8.8 replaced the 9". it...
the I6 motor hangs further past the front axle center line. this puts move of its weight on the front springs the the v8 does. i remember people...
the must probable suspect would the the secondaries of the edelbrock carb are not fully opening. the main throttle plates may be opening all the...
plate between engine and transmission flywheel bellhousing t5 transmission crossmember shift lever clutch pedal either a hydraulic or clutch cable...
what carburetor are you using? what fuel pump are you using? what sizes are the fuel lines? do you know anything about the valve springs? were...
Separate names with a comma.
