Just one more thing on the heating and pin fit process. Be sure and check each pin in the matching piston, to make sure it fits without binding or...
Do not stagger them, it will defeat the real purpose of a 4 link set-up. Instant center, pre-loads and a bunch of other tech stuff, are involved....
Go to a solid roller and you will see some difference. I assume you are running flat top pistons too, which is alright for your application, but...
I for one, would definately want to see the pic's. That should end anymore "will they or will they not go in the stock location". I think the main...
Just installed one of their torque converters(5000) stall, behind my 347 Fearmont. Is doing ok so far, but does seem a bit to loose on the top...
Tom, I think I still have one of those dipsticks in my shed. I will look tomorrow and if it is still there, will PM you and get it to you ASAP.
First of all, my post did not say that all direct drums are five clutch. I said they can be made five with a simple use of other parts from "any"...
Some say that the pan fill one's are the better and stouter because the bell housing bolts to the case rather than the pump. They also have five...
Great job Tom, hope you put them all on the trailer and take home some money. Glad you are back in the seat and having fun too. Keep us posted on...
Well now, this has been a very interesting post to follow. The original question was about just installing a longer stroked crank in a 302 without...
Be sure the oil level is full. Best to check it first thing in the morning before start up. Sounds like the oil is being thrown to the back of the...
Congrat's on your efforts and it is always frustrating when things tear up and time is a factor in getting ready for the next race. Our efforts...
Any c4 modulater shaft should work, my use of 1/8th drill rod to make them, as Paul said, work's great and you can get a whole bunch out of a 2ft...
Possable but could also be a lifter or the poly-lok itself. Had one that the set screw jammed and would not allow the nut to go down anymore. Try...
Just got home from the track, was going to tnt tonight after checking the converter bolts on the glide install a couple weeks ago. They were tight...
Should go in as a unit fine, but you may have to leave the hoist on and install the headers, if used, before lowering onto the mount's. Did you...
"huh" ?
I don't think he rebuilt the tranny, just the motor and used his existing c4 that was working ok before the engine rebuild. Hope he gives more...
Hey Simon, that is a real concern for us. When you fill the block with "grout" it only comes to half way up the water pump holes in the front....
Every 302 race motor I have built are .060 and usually hone another .001 out. They do run a bit hot in 90 degree weathr on the strip at 7000 rpm...
Separate names with a comma.
