what does it do? is it required? thanx
do these engines use a block plate to align the starter like the sbf motors? thanx
dont misunderstand, i do have all of the equipment to take out the ballast & run under 9.99: i just dont do it very often. i went to the...
re 351 w - can a 1 piece seal crank be used in a 2 pc seal block? can a 2 pc seal crank be used in a 1 pc seal block? if not, what must be done...
wait'll you put on that 3 layer pants, jacket & collar in the afternoon in august & sit in the car waiting for your lane to move. that's why i...
i believe mopar slid the leaves forward so you got added stiffness in the front part of the spring. i have a hunch you would still need some kind...
means 1969, but thats just the casting date. could have been used for years with various internals. i think the duraspark started in 1975. was...
anyone know how to get the reluctor and rect assembly out without breaking them? i wanted to put in light adv springs, but cant get the plate off...
if its a small bearing 9" then the 8" stuff should swap onto it.
i usually lean toward the 289 torker. can usually find them on ebay for a song. dont get one thats got much porting done to it. its just fine...
you put extra shim in the spider gears. makes them bind a little and not spin one side as easy.
not a problem. just depends on power, trans setup, suspension. knew a guy back in the 80's with a nat record holding camaro with a power glide...
i seem to recall that the xcelerator is similar to the torker 289. i would try an open spacer before doing much grinding. just some port...
if both wheels have traction, both drive. if one spins, all power goes there. when mine broke, it was a pretty sharp turn. didnt damage...
all the flow is along the top of the plenum & the ports. thats where to do the blending.
the car will try to make a sudden turn toward the broken axle because the good side is doing ALL the pushing. i went directly toward the xmas tree...
sssshhhhh. be quiet. most of the ford guys think the world begins & ends with the words rpm & air gap. you'll raise the prices on ebay for...
scooper - keep in mind that the mini spool did not break that axle. a full spool would have done the same thing as would a ratchet type locker....
directly over the rear axle tube on the rear subframe, if i understand your question correctly.
yea! always good to hear positive results.
Separate names with a comma.
