I just measured mine. About 1" a little more in some places, a little less in others. I went with this insulation from Home Depot. Southwest...
Someone mentioned using the Fiberglas original type stuff, I'm thinking about that. I also have many sheets of 1/4" blue " fan fold" foam. Where...
That's the post I saw too, Got another day or two to think about it.
I checked up on the peel and seal on other sites, some say the glue will turn loose in the heat. Being in Texas worries me about the heat.
Where can I get dynaliner?
Replacing my headliner, and the insulation is not reusable. What does everyone use? Looking for cheap too.
I just put a 60hp nitrous kit on mine when it was a 200... made it fun!
What else on the menu???
Sounds good to me!
Deep Ellum Glass in Dallas has them in stock. They even take them to swap meets. $125.00
We are lucky here, there seems to be plenty. Plus Rick Brooks keeps the parts available.
I've run C6's behind SBF's, that is a power hungry trans. I'd stick to a C4
Surpised it didn'y have an LS swap....
I've also seen shops tie bungee cords to them also, anything to keep them from hitting the ground!
So, I have to drive to Oklahoma for a free alignment?
They all "look" identical, but if they are the wrong ones, they will dig into your door panel, since the shaft part of the crank is shorter. Look...
Not yet, I just got my windshield, and the car is in the body shop getting the rear frame rails straightened. Next week or two.
You could set the fronts down on some sheet metal to help them slide some, will only work on smooth concrete though... But looks like you're...
I've got one of those early carbs if anyone needs it.
If it's an auto, pull the driveshaft. Not sure on all transmissions, but I know most will burn the internals up if you don't, the front pump is...
Separate names with a comma.
