If the windshield gasket is pliable and you are VERY patient, it can be done without removing the windshield, but I have never been able to do it.
That looks great. I was pretty confused until I read that you were using a Vintage Air setup.. I had been trying to figure out how you were going...
It's ok Gene, I thought it was funny. :rl:
When I did mine, I started out using a piece of copper pipe I flattened out to put behind the holes. Without a helper to hold the copper for you...
I always wondered whether you could replace the trunk floor in a 70 with one from a 71+ car, probably the rear crossmember too (never looked up...
Nice work. I like the boxes... taller and safer to use with jack stands than car dollies. Nothing to say about the shop that hasn't been said...
Amen brother, preach on! :thumbsup:
I am pretty sure the fan spacer I am using would clear that water pump pulley fine. It is the longest one I could find since I don't have shroud....
Yeah, if the humidity is low it will not drip much. Whenever the humidity does go up, try it again. If it's not A/C condensate, then there are...
Yeah I thought of that. :D Imagine the torque of over 500 cubic inches. :thumbsup: I didn't mention it because usually if someone has access to...
Been a while since I had this conversation with him (yeah, it comes up once in a while on here :D) so I can't remember specifics on it. I seem to...
Not true. Robert (Mavericknutt on here) did not modify his tunnel for his C6 and had no issues. Might talk to him about motor placement....
Separate names with a comma.
