Head gaskets were victor reinz, and measured .055 thick (.035 squish). The intake valves looked very close to deck level. I need to go back and...
Welcome to the forum! That is a beautiful car....and yes, like the wife said, they are money pits. As long as you understand that up front, its...
I found the 8 video re-assembly series. I gotta figure out what I can and cant do with this thing, and add up the cost. I may just return it to...
That is an awesome series of videos. I am gonna hunt down anything he does in the rebuild department and check them out later on.
I should go back and measure how thick the head gaskets were. I thought there needed to be at least .035 clearance from piston to head? It may...
This is the current firing order. I also put the back of a hacksaw blade across #1 when out of hole and a .020 feeler slipped between it and the...
Welcome from Portland, OR. Thanks for stopping in and showing us your car!
I have been watching for a low mile roller 302, and finally saw one in a 73 mustang that looked like a rebuild. It was easy to identify as the...
Late welcome from Portland, OR. Hows your bodywork coming?
They usually stay on until you carry your driveshaft somewhere....then they fall off when you are not looking.:drool: If they still have grease...
2.83 & 3.08 Axle ratios?
I have a points distributor, but the points are used as a signal for a TFI module and coil out of a early '90s truck. It is not as fussy when cold...
Separate names with a comma.
