C4s can last 20 years or more. If you had it rebuilt then return to the shop on warranty. If they won't cover it then call the BBB and your local...
The auxillary cooler should always be connected to the return line of the transmission. The factory line has a large "U" bend just before it goes...
You can change the direction of reverse by installing the reverse lever at the transmission 180 degrees - instead of left and up it will be left...
there are minor differences between models. The length of the output shafts and extension housing. There are differences in the outside diameter...
the front line on the C4 is the pressure line and the rear is the return. Looking at the radiator as though you are sitting in the driver's seat...
no..... depending on the model and years being compared.
Check the vacuum at the modulator - it has to be 10 or above. Could be a bad hose at either end of the metal line or a cracked line to the...
It is common to see smog pumps modified to run on small Briggs engines but they just don't move enough air to supercharge an automotive engine....
Yes - it controls flow from the block to the core.
Reverse manual valve bodies pattern is PRN123 - it prevents accidental shifting into neutral going from 2-3.
If the headers are properly tuned to the port timing reversion cannot happen. You have to tune the primary pipe diameter, the primary tube length...
If the drain won't light a bulb then it shouldn't drain the battery overnight.?!
Gear whine???? That doesn't sound right.
disconnect the negative side of the charged battery and place a light between the post and cable. Then start disconnecting things until the light...
Just a thought here but taking more than .060" out of a thin-wall casting is asking for trouble unless you check to see that there was no core...
I would recommend that nothing gets attached to a radiator with zip-ties. They will cause wear and they do not stop vibration. It is faily easy to...
You should block the accesories (normally on with the IGNITION but off when cranking) so you don't cause problems with low voltage while cranking...
As long as the flywheel is truly neutral balanced then you will be fine. Paul
You do have to remove the valve body but it can be done with the transmission in the car. Once the valve body is out, it is a matter of pushing...
The starters for the manual and automatic use the same distance from the mounting surface to the gear - the difference is in the nose casting. You...
Separate names with a comma.
