see post #4........ David
Miguel has it correct, charcoal canister was connected to OEM air cleaner housing via flexible tubing. David
From the close up pictures, looks like you do have the correct OEM matching upper/lower bar halves, regarding the welded threaded insert, perhaps...
I installed the grease fittings way back when, made it so I could grease/lube the bushings which lasted over 35 years before I went to hydraulic...
How is that threaded insert attached and have you tried to remove it? David
Looks like someone may have modified the engine side, did not have that threaded "insert", also you have a mis-match, the engine side, lower bar...
I had the same problem many years ago, I ended up fabricating a spacer between the carb and air cleaner bottom, not sure if these spacers are...
http://mmb.maverick.to/attachments/img_1623-jpg.131698/ David
Those look like ones from early 65/66 Mustang......... David
walt@federlineproducts.com he maybe away, usually prompt in returning messages, so try again or can phone him as his number is also on website. David
I purchased one of Gerry's 6 gauge Cluster panels back in May, well made, at the time he mentioned after the few he had left where gone, was going...
Probably would be best to contact Walt and talk/message him about how exactly his new locking design operates and perhaps he could shed some light...
Hi Craig: During my conversion with Walt on Nov 23rd., here is part of his message........ "currently has 48 assorted hinges in the works, 10...
They where a direct bolt in, spacer/washers (supplied) where used between the inner fender/hinge to make sure hood/hinges are correctly aligned....
Yes, only one side has the "pin", Walt is working on a "new/revised" version, which eliminates the pin, I believe he already incorporated them...
Hi Chip: Perhaps you might be interested in Billet Aluminum Hood Hinges? Contact Walt Federline https://www.federlineproducts.com/ I was his...
https://opentrackerracing.com/frequently-asked-questions/ information on roller spring perches, item #3 David
Are you getting the "rollerized" spring perches? David
The "bar" you maybe referring to sounds like the Steering Center Link? David
I used a Stewart Warner p/n: 82342 Electric Fuel Gauge, which is correct for our OEM 73/10 ohms sender....... One wire signal and other ground...
Separate names with a comma.
