It is not as bad or difficult as it may seem, see my posting/pictures on replacing rag joint with U Joint....
Member Tody (Thomas) goes into great detail of how he solved the issues, starts on his post #714........
Yes, there where 2 different size center hole on factory steel rims, along with Hub size 2.43" and 2.78" My factory original 14" steel rims from...
I remember years ago someone in the marine industry telling me not to use copper lines with gasoline......... "Now, copper interferes...
If roll pin is worn, can always get a new one at any hardware store or a #8 bolt will fit fine too......... David
Looks like the voltage regulator.......... David
Read my post #4....... http://mmb.maverick.to/threads/fuel-injection-question.121249/#post-1150044 David
My 74 Comet 2 door with 302 had a 120 MPH speedo......... David
Welcome from Vancouver, there are a couple members who live on the Island too! David
Hi Everett: Both my 73 and 74 Comets where column shift auto's, when I had my 74, converted it to manual Toploader 4 speed, but left the column...
Got the steering column installed........:bananaman: David [ATTACH] [ATTACH] [ATTACH]
Finished the steering project..........now the shaft is supported by the original upper bearing and new lower bearing. I still have my original...
Finishing up U-Joint project on steering column, fabricated collar for bearing and pressed tube to fit 3/4" DD shaft, just have to cut shaft to...
Staying with the 4 speed for now......
Finished up the MDL Hydraulic Clutch Pedal linkage/rod, new hole drilled in pedal, made a coupler out of brass pipe fitting, everything lines up,...
Hi Everett: I was going to replace the column shift lever collar with one from floor shift that does not have the lever, so while I was at it,...
Finally got the Stainless Steel reinforcement plate for the MDL (Modern Drive Line) Hydraulic Clutch Master Cylinder done and test fitted,...
Switzerland actually....... :)
Yes, Eric is going to be busy removing them today, 43 tags! David
Found this on youtube, dyno results for both 69 Boss 302 and GM DZ302........... [MEDIA] David
Separate names with a comma.
