WD40 around the throttle shafts where they go thru the throttle body and work the linkage several (20-30) times and squirt it every 10 pumps or...
Keep the small diameter, stock appearing distributor and out a Pertronix in it. HEI belong on Bowties, period. Hate the look of that big lump...
The rougher surface of anything but paint will be much harder to clean and keep looking good. Paint it. SPark
Didn't take it that way at all. Glad to se you have N2O experience already. SPark
Good billet adapters are around $125 a pair. You can get about any bolt pattern you want. The thinnest I am comfortable with are 1.25 thick....
I have run the 1011-2 gasket on 14:1 motors. I also use head studs. From all the engine questions you post, I think you should build a solid,...
Are you running a hundred shot or several stages? Big difference. SPark
According to Edelbrock, a low compression engine with 7/16 head bolts and without nitrous should use a FelPro 9333-PT1 which is .047 thick. Low...
Great guess, Dan! -4cc of piston volume 60cc chambers .041 thick head gasket -0- deck 4" bore 3" stroke That makes it a 9.54:1 Using a .054...
Does it get so hot it shuts itself down? That would cause damage every time it happens. Does your temp gauge show extremely high? Does...
My HF lasted all of 2 minutes before smoking itself. I have a new Porter Cable I gave $29.99 for Tuesday (and it included 4 grinding wheels...
What do you plan to do with the car? Drag race or street driving? Big difference in parts depending on usage. I would suggest calling a couple...
Anytime you can trade an Edelbrock carb for something even remotely usable, do it! Sounds like you are getting a handle on it. SPark
Like I stated above, it's not about the bolt pulling out of the tube, it's about the crossmember pulling out of the sheetmetal as it flexes during...
I just mig weld the groves back in and finish them with a little angle grinder. Good as new and last a long time. SPark
I wasn't referring to the bolt failing. What fails is the weld rips out of the sheetmetal where the crossmember welds to the bottom of the frame...
Anyone can restore a car, takes a real man to cut one up! SPark
On some models you have to flip the nut over. Look to see if your nut has a recess on one side. The recess will fit down over the hub of the...
Something to consider. If you are using the strutless lower control arms, you may want to run a gusseted tab from the lower control arm mounting...
73ohm empty/10ohm full http://www.speedwaymotors.com/electrical-fuel-sending-unit-and-guage-testing.dlp SPark
Separate names with a comma.
